1984 Chevrolet Monte Carlo "wires used alternator plug" Questions

unplug plug,remove belt , one bolt on top one on bottom use pry bar to loosen and remove  install in reverse order make sure battery is charged before start or damage to new alternator may occur

...used to charge the battery When the alternator can no longer supply the required power then the battery eventually goes flat have the battery load tested to check that it is serviceable Sounds like ...

...plug if there is no spark at one or more plugs check the wires and coil or distributor (i'm not sure if that car has a distributor or coils) if you have spark check for timing being out of spec.if a ...

...wires which caused the rotor damage. secondly if you have a distributor check that the pick up coil is in good condition check for continuity using an omh meter, disconect the wire coming out of the ...

...wires. I need the wiring schematic for the wiring from the alternator plug to the regulator on the alternator. The alternator plug was oval not round, was damaged in an accident and I can't find a ...

...alternator. Turn the key on and check for power and ground at the leads. No reading, probe the wires a couple inches back. If a read there fix or replace the plug. If you have a 3 wire plug, best to ...

...alternator plug and the wires behind it back together, when I go to connect the battery the negative post sparks and the 120 A fuse that goes to the negative hookup for the alternator (in the ...

...PLUG on the alternator have only one wire a red wire, should there be another wire? a lot of gm vehicles use a single wire alternator the only way to tell is to either look at the back of the ...

PLUG THEN LOOK FOR A CONNECTION ON THE BOTTOM OF THE ALTERNATOR. IF NOTHING IS ON THE END OF THE WIRE, THEN HEAD FOR AN AUTO PARTS STORE WHERE THEY WILL HAVE THE APPROPRIATE PLUG OR WIRE CONNECTOR FOR

...used to put out the light on the dash when its charging.next there is a D shaped hole on the back of the alternator that you can insert a metal cotter pin into until you feel a tab and ground the tab ...