...front. There is no wear on them but when the brakes are applied there is this awful grinding scraping noise coming from the rear. We can't figure out what is causing these problems whoever did the ...
...front brake rotors machined an a amco brake lathe or even better a on the car brake lathe. make sure all brake caliper hardware is properly cleaned an lubercated or replaced with new hardware....then ...
...front rotors rubbing. What are these for? 2005 Chev Equinox they are called wear indicators time to replace your brakes before they damage the rotors their pad retainers there's an upper and lower on ...
...front disc brake'' remove all connection bolts , clips. I then slowly pry the brakes as far from the rotor as posible ( depressing the brake cylinder) with tire tool or large screw driver, so the new ...
...adjusted. Unless you replace these components, you will face a constant battle to keep the rear brakes adjusted and will invariably be wearing out front brakes and rotors much faster than the
...front flex lines. Calipers don't seem to be sticking as I can push them back with a C clamp. I drove the truck after I replaced the hoses and it seemed fine. After it was parked for a couple of hours ...
Question about Ford Cars & Trucks
...replace the wheel cyliners need to be replaced ,that is most likely where it is leaking , recommend bleeding the brake system both front and rear after changing the rear wheel cylinders i would ...
to slide on my 1995 camry front brake caliper? Replace the caliper. Once you buy a torch and a caliper hardware kit and spend the time to get it free it will be cheaper and faster to get a new caliper
Question about Cars & Trucks
front break caliper sticking. what could be the problem ? it needs to be rebuilt, pins greased and replaced, hardware kit installed Probably needs cleaning and lubrication as per the service manual to
...front rotors turned and new pads. i recently replaced rotors pads,and hardware. the problem is back i have good pedal now the pads are dragging and a hard binding noise when applied. it seems as ...
1,011 questions posted
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
688 Questions