2001 Pontiac Sunfire "remove replace radiator" Questions

...remove the hose unbolt the enclosure and the Tstat should be right there. replace with new scrap all the old gasket metal on the housing, use a new gasket and re tighten and fill the radiator. After ...

Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run

located under the housing where that hose connects. Remove the hose and then remove the housing. Make sure you clean the old gasket off completely and install a new one when you replace the thermostat

...remove the rad cap, start up the engine and let it run till it reaches temp -- tighten the drain port and refill the rad, and the overflow to full. try all that and God Bless. the exteme heat to melt ...

replace it. Is the cooling fan running? If not check the fuse & thermal relay. If it has a bleeder valve it will be located on the highest part of the cooling system. It may not have one. With the

...replace water pump on 97 pontiac sunfire 2.4 PLEASE DON'T FORGET TO RATE! THANKS!2.3L & 2.4L EnginesDisconnect the negative battery cable Detach the oxygen sensor connector. Properly drain the ...

...replace the theromstat Follow the upper radiator hose back to where is clamped to the engine. The part that the hose clamps to is called the goose neck the t.stat is under this part. You will need to ...

...replace it. The water pump is responsible for moving water and coolant through the engine, to the radiator and back to the block. The coolant absorbs the heat from the engine, then cools down in the ...

...replace it? 2.2L Engine Disconnect the negative battery cable. Properly drain and recover the coolant until the level is below the thermostat. Unfasten the coolant outlet-to-inlet manifold attaching ...

radiator leaking radiator drain plug leaking Try to tighten,if that doesn't work,drain coolant and remove plug and take to auto parts store and ask them you need a replacement.