...but the belt may have struck the crankshaft sensor. The sensor is behind the crankshaft pulley. Check the wires going back to the sensor and repair as needed. Let me know if you have more
Question about Pontiac Montana
...opinon The code is probably for the crankSHAFT sensor. The sensor may not be sending a signal to the engine computer. Depending on the actual code, the sensor and wiring would need to be checked
...replace. They are usually right 99% of the time.The crankshaft position sensor located behind the harmonic balancer maybe be bad. There is another crankshaft position sensor located on the engine ...
...replace any parts u need to have the electronic engine control tested for trouble codes, this is the 1st thing that any shop does to know where to start the repair and diagnosis. Most likely u have a ...
...crankshaft position sensor replaced. sam problem. I'm chasing a ghost here and the car will strand me for an hour or so before it starts again. any advice would be great. thanks check that the ...
...Crankshaft position sensor could be the cause ! Take it an have it hooked up to a scan tool and or a oscilloscope to know for sure ! Also have voltage drop testing done on charging system an engine ...
Question about Pontiac Montana
...crankshaft position sensor. try this link https://diy-auto-repair.wonderhowto.com/how-to/replace-ignition-coil-chevy-venture-montana-423534/ Question edited for clarity and written English, 'n' isn't ...
...Replace Camshaft position sensor and Crankshaft Position Sensor? http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html ---------- GMC Crankshaft Position (CKP) ...
Question about Pontiac Montana
...replace the crankshaft position sensor remove heat shield disconnect the electrical connector the remove sensor retaining bolt then remove crankshaft sensor.after replacing crankshaft sensor you need ...
replace the main computer board in June because it wouldn't communicate with the State's OBD for inspection. Had to go to heavier weight oil because of flickering low pressure readings
1,202 questions posted
Usually answered in minutes!
613 Questions
518 Questions
483 Questions
458 Questions
361 Questions
