2000 Pontiac Montana "install new brakes front" Questions

...new rotors,brake pads, bearings and tie rods to front of 2000 montana. have a whopping sound when driving , this goes away when wheels turned slightly right. when turning right corner hear a clicking ...

...new cable when removing the engine from the vehicle. In order to avoid cruise control cable damage, position the cable aside while you remove or install the engine. Do not pry or lean against the ...

...Install new gaskets and connect the brake hose to the caliper with the banjo fitting bolt. Torque the fitting bolt 22 ft-lb (29.4 Nm). Fill the reservoir with brake fluid. Bleed the brake system. ...

...new, thicker pads over the rotor. A large C Clamp works best. SECTION 206-03: Front Disc Brake 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Pads ?Front Disc Brake Removal Remove the wheel ...

new rotors and it still grinds when I step on the brakes. I replaced the front brake pads and installed new rotors, but it still grinds when I apply on the brakes. What should I look for? Try checking

Install disc brake caliper and new caliper anchor bracket bolts on front disc brake rotor . Tighten caliper anchor bracket bolts to 88-118 Nm (65-87 lb-ft). CAUTION: Failure to tighten lug nuts (1012)

...Install new brake rotor, the new rotor is manufactured with a protective film over the rotor to keep it from rusting, remove protective film with brake cleaner before installing; also after the brake ...

...Install new lower ball joint nut. Tighten to 68-92 Nm (50-67 lb-ft). Install tie rod end into front wheel knuckle . Install new slotted nut and tighten to 47-63 Nm (35-46 lb-ft). If necessary advance ...

...new ones in the wheel hub retainer wont come off any suggestions ? There should be access hole to install the studs without removing the hub & bearing assembly. If not the assembly will have to ...

new brakes Installed new brakes front and rear including new wheel cylinders, shoes and flexible brake lines in rear at drums, new calipers and pads in front, new master cylinder. Cant get front ...