p1635 where located the crank position sensor 3800 engine it is behind the harmonic balancer (crank pulley) on the right side.3400 engine it is above the oil pan on passenger firewall side of engine.
...firewall. Heater core leak would more than likely put steam in the vents of you car when heater is on and hot and fan on. If the leak is just in the engine compartment, it`s a hose or a loose ...
...fluid this is a sealed transmission, no dip stick tube, there is a fill plug on the side of the trans, but need dealer tool to fill correctly. its on the rear of the engine near the
where is o2 sensor stage 1 sensor located...looking for pictures Its located in the exhaust manifold between the engine and firewall.
...firewall. Try removing the air filter and air box on the driver side. Then see if you can reach the back side plugs out. You have to tilt the engine towards the radiator to gain access. Just get a ...
...engine, at the 'firewall', which is the engine compartment metal wall that separates the inside of the van from the engine compartment. Is it low, or empty? If the fluid is down, there is a leak ...
Question about Pontiac Montana
...firewall side of the engine, and senses the harmonic balancer at about the 10 o'clock position. The other one is buried *under* the balancer, and is held in place by two of the screws that ...
...yellow should be crank sensor and it plugs into the coil pack on the drivers side closest to the ...
Question about Pontiac Montana
...firewall side) wedged in between the engine block and transaxle, that one is a bit tough to get to. Do you have a code for this in your computer? If not, is the check-engine light on? If it isn't, a ...
...firewall behind engine, where it connects to the heater core's fitting that juts out from firewall. Hose goes over that fitting. Heater hoses are fairly easy to replace, maybe not so easy on yours, ...
1,202 questions posted
Usually answered in minutes!
613 Questions
518 Questions
483 Questions
458 Questions
361 Questions