TPS, plugs, plug wires, rotor, points, etc. Nothing seems to help. Any idea why this is happening? Thanks for your advice. I have used this procedure for years. Here is the most common cause of surges
...I would like to know if theres a way to reprogram the tps sensor with out taking it to the dealer. I was unable to find anything on any of the Nissan forums Scanner required for relearn
code for tps changed it code came back and bangs into frist gear Some cars like cadillacs have a relearn procedure for the tps. Look it up on www.alldatadiy.com
...relearn the tps? P1545 code is Throttle Pos. Contr. Malfunction.......Check Trottle valve Control Module... 1998 vw 1.8 trubo passat. When I drive it the gear changes so fast n after a while when I ...
Question about Pontiac Fiero
...TPS) and tried again. Same thing, I could not get it to connect with the ECU. I have a Autel Scanner MaxiCOM MK808S, so we can read the ECU if that will help? Question edited for clarity. Question ...
Question about Pontiac Fiero
...a 2000 Impala 3.8 changed tps now it doesn't go below 4000rpm can you please help need to do a relearn procedure https://www.youtube.com/watch?v=NAnEoMa80VY ...
Question about Pontiac Fiero
...relearn procedures after replacing the throttle body and the throttle position sensor (TPS) . Check for Other Issues: Ensure that the ignition coils, spark plugs, and front oxygen sensors are in good ...
Question about Cars & Trucks
tps) when jumping, or battery voltage is low. Pulled cables and car still ran so assuming not an alternator problem. You have to do a throttle relearn procedure after disconnecting the battery. You'll
Question about Kia Cars & Trucks
...tps but I replaced the parts and the Kia will turn on for a few seconds then turns off. I checked all sensors/fuses all good. There is no idle relearn procedure for this vehicle. The computer will ...
Question about Pontiac Fiero
...tps tests ok, the relearn procedure is simple. Disconnect the battery for 30 minutes or so. Reconnect the terminal and start the engine. Just let it sit there idling for 10 to 15 minutes. Then turn ...
206 questions posted
Usually answered in minutes!
91 Questions
85 Questions
62 Questions
65 Questions