2006 Ford F-250 Super Duty "idle speed" Questions

idle speed problem when u push in the clutch to shift gears the engine rev's up and wont stop till u tap ******* the gas feed . i have put on a new cable and an idle speed motor . I had a similar ...

engine will not idle 5,8 4 speed idle speed too low.should be 700 rpm. idle air control valve tps head problem/valve/cracked head/head gaskit

...idle speed screw on the carburetor throttle-raise the idle some, it will open the throttle plate a bit when you turn the screw in. Idle speed should be about 800 rpm's, with truck in drive, foot on ...

...idle speed control device... See below on diagnostics The curb and fast idle speeds are controlled by the Engine Control Assembly (ECA) and the Idle Speed Control Bypass Air Valve (ISC-BPA) . The ...

...idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or ...

...speed varies at idle. Trottle position Engine speed varies at idle. Trottle position sensor and idle air valve have been replaced. Any suggestions Check the operation/condition of the PCV valve and ...

ford f250 has a miss firing at idle and when speeds reach 40 -60 I just replaced spark plugs and spark plug wires, engine still has a miss fire at idle and at certain speeds. Did you replace the dist ...

...then drive. PLEASE HELP SOUND LIKE IDLE SPEED TOO LOW HAVE IDLE SPEED CHECKED. REPLACE FUEL FILTER IF IT HAS BEEN A LONG WHILE A FAULTY TRANSFER PUMP OR FUEL INJECTION PUMP WILL CAUSE STALLING ...

2004 f250 cranks, won't start before no-start, had high 2500 rpm idle speed, had moaning sound at idle prior to hi idle and no-start Sounds like you need a new starter, installed.

...idle speed in this engine is controlled by a part called the ISC, they get full of sludge and cause stalls, please do the following and it should clear up the problem. To correct this problem get a ...