2004 Ford F250 "egr valve sensor 2005" Questions

Ad

...egr valve .The sensor is about$70 and faily easy to do .:) its a 6.0 liter diesel it doesn't not have a dpfe P0401 is Exhaust Gas Recirculation Flow Insufficient Detected i'm positive that your egr ...

Ad

...and that always preceeds the "bad" hesitation when strting off. Joe in Jacksonville, Florida It sounds like your EGR valve is sticking, the EGR valve position sensor is bad or the EP sensor is

Ad

...EGR valve has gone out on my 6.0 diesel how hard is it to remove and replace EGR is at the back of the engine near the fire wall in the middle and is easily accessible. It looks like a 7cm space ship ...

...egr replaced cause of over heating and white smoke out of tail pipe. After that was done the check engine light went on and thats what its telling me, drove around for a while but now it didint start ...

EGR valve or restricted portsBase engine concerns: low compression, valve train problems and timing issuesIgnition system concerns including, but not limited to:   Faulty spark plugs  &

Question about Ford F-250

1 Answer

EGR valve and sensor has failed. EGR valves were a common failure item for the 05 Caravans. Ours died at 42k miles. The sensor and valve are serviced as a unit. Expect to pay $150-200 to have it done,

...egr valve sensor code error I have a 2005 magnum (2.7 liter) The check engine light will come on peridocially, then go away, then come back on. P0406 is the code I get. How do i know if its a bad ...

Question about Ford F-250

1 Answer

...volume control solenoid valve harness is open or shorted - EGR volume control solenoid valve circuit poor electrical connection - EGR volume control solenoid valve - EGR temperature sensor and ...

...find one. Is it part of the EGR Valve? yes it is..you need to replace egr valve assembly..make sure you disconnect battery while replacing..some times fault will return even after replacing

Question about Ford F-250

1 Answer

p0408 engine light code po408 refers to exhaust gas recirculation(EGR) valve position sensor high input===causes--wiring---EGR valve position sensor--ECM . Try replacing the sensor for the EGR unit.

Not finding what you are looking for?
2004 Ford F250 Logo

655 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...