2003 Ford Explorer "causes knocking noise" Questions

...Knocking and Ticking ' Common Causes www.justautorepair.com/whats-wrong-with-my.../knocking-ticking The following are causes of connecting rod bearing noise: ... Loose torque converter-to-flywheel or ...

...knocking noise that sounds like it's located inside the left rear panel of the car? Noise stops when car is off or when key is in the auxiliary position, starts as soon as the battery turns on or the ...

...the knocking noise. If it sounds like it's coming from the top then I would suspect lifters. If it sounds like it's coming from the bottom of the engine then I would suspect main or rod

...knocking ABS sensor out of range causing ABS light to come on and causing grind noise at same location. Grinding noise is probably rotor rubbing on calipar. Have seen quite a few fords that the abs ...

...knocking, or tapping noise is the rear blend-door motor. if you remove the rear left panels you will see a black case with hoses coming out. there will be a white, or black plastic box. (About the ...

2001 ford Explorer - engine rattling - is that timing belt/chain Have a 2001 Exp with approx 120k miles. Recently started hearing knocks in engine. Never had belt changed. Could that be it? What ...

I have a 97 Ford Explorer that makes a loud clunking noise during acceleration...if I baby it it doesn't happen and it goes away after I've reached 50 or 60...only happens during acceleration could be

...noise that sounds like knocking when i drive and turn, but not when sits idol. do you know what may cause this? Its coming from under the vehicle. that's all I know. I had my tie rod and ball joints ...

...knocking noise. The oil is fine and while I can hear it with the hood up, it seems to be more prominently heard when I walk around to get in. As though maybe the noise is coming from the mid-section ...

...knocking noise. This will be accompanied by a low pressure, or illuminated oil light. The next issue will be worn, or damaged rod bearings. These vital bearings can fail if the bearing clearance is ...