cylinders it first was #2 but now both i change the coil again and it reads the same thing since the problems appeared after the work, it is in the work. prob is in wires or plugs.. take no 1 plug out
Question about Ford Taurus
...1. Changed out plugs and wires, 2. switched wires around, 3. replaced fuel injector, 4. replaced coil. Still misfires. That being said, I seem to have a small unnoticeable coolant leak. There is ...
...plugs what els could be wrong If you have a multimeter, check the resistance of the spark plug wires, especially the one going to the number 1 cylinder. The resistance changes as the wires
...cylinders if one cylinder is less than 10 psi different from the others that can cause a miss, last but not least check injector pulse using a noid light for injector pulse if pulse is good then ...
need to run a compression check on all the cylinders, I'd emagine they should all be running at approximately 150psi per bore, if 1 & 6 are down it could be the head gasket, timing or piston rings
...change the wires and plug wires om my taurus? Follow the wires from your ignition coil (located at the drivers side of the engine) to the spark plugs. Unplug these wires. Using a 5/8" sprak plug ...
...or the oil filter not installed corectly please help the car ran smooth up until i had the oil changed ...
...0 no compression #1 cylinder 3.0 eng runs rough so changed plugs. has good wire NO compression #1 cylinder whats wrong how to repair Here's a link Robert to your problem. ...
...change the plug and wire on cylinder #1. If this doesn't solve your problem then you can go to your coil packs and change that. If that still doesn't solve your problem then it may get difficult ...
Check engine light is on.. Computer analysis says that # 1 cylinder is mis firing...I've changed plugs, wires, and coil pack..Any idea where to look next? fuel injector on 1 is faulty
3,187 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
1,869 Questions
1,431 Questions
1,365 Questions