2000 Ford Contour "install routing 2" Questions

routing chart under the hood before beginning. There is a tensioner pulley mounted on a spring arm, the spring arm should have a square drive hole in it, either 3/8" or 1/2" drive size you will need a

...12 Volts across the right rear brake light socket contact and the socket's ground contact (no bulb installed), but the voltage dropped to near 0 Volts when the brake light bulb is connected to the ...

...routing grommets into the dust shield and steel bracket on the frame. Route the wire into the engine compartment. Install the rubber coated steel clip that holds the sensor wire to the frame into the ...

routing-Fan pulley (1), Fan belt (2), Crankshaft pulley (3)-3.0L engine shown PROCEDURE Removal & Installation 2.7L Engine 1. Loosen the tension adjust and remove the A/C compressor drive belt. 2.

...routing and removal. When you look at the engine and all the pulleys that the serpentine belt goes around, one of those pulleys will have a "tensioner" on it. On that "tensioner", there should be a ...

...install: While referring to the proper routing diagram (which you identified earlier), begin to route the belt over the pulleys, leaving whichever pulley you first released it from for last. Once the ...

...2 Disconnect the ground (black) battery cable using a wrench. This will prevent the cooling fan from activating. 3 Locate the serpentine belt routing diagram in your engine compartment and compare it ...

...Install the accessory drive belt (2) around all the pulleys except for the generator pulley (3). 2. Using a wrench, rotate accessory drive belt tensioner (8) counterclockwise until accessory drive ...

2 inch breaker bar. Relieve the tension and remove the belt. Be careful, its heavy spring loaded. Make sure you know your belt routing for installing the new one. There should be a sticker with a belt

...install: While referring to the proper routing diagram (which you identified earlier), begin to route the belt over the pulleys, leaving whichever pulley you first released it from for last. Once the ...