2000 Ford Contour "drive force" Questions

engine cooling fan won't come on while driving The electric cooling fan is not needed while the car is driving down the road. Air is being forced through the radiator and provides enough air flow ...

...drive. Then place the extension on the block of wood ( a depression in the wood will help) and then apply force to your end of the extension. You can use another piece of wood to save your hands when ...

replacing timing belt on a 1999 ford contour 2.0 i cannot find any diagrams to help me time the car correctly, the old belt broke while driving so i dont know where the camshafts go relative to the ...

...drive rachet to swing back the idler pulley so you can install the belt. Don't know which engine it is, but find the idler pulley and move it back as in the instructions above. You attach the wrench ...

...rear and the car will not start, look for the shut-down switch in the trunk. It is usually on the driver's side under the

...DRIVE position against rearward stop. The floor transaxle range selector lever must be held in the rearward position using a constant force of 1.4 kg (3 lb) while linkage is being adjusted. Loosen ...

...drive belt. Lower vehicle, then remove traction assist module bolts and position module aside. Rotate power steering pump pulley to gain access to each pump front mounting bolt, then remove three ...

...off. Went back about 1hr later to restart, and it didn't work. I drove around some today, while I drive I can feel heat and it blows some but not as good as it should on a high setting, when I stop ...

...voltage meter lead the same way you would in a battery static voltage check, Start engine (do not drive) at engine idle the voltage should be between 13.6 to 14.3 volts. If not the alternator may ...

...drive once but shift feels free like linkage or something is not connected. linkage will probally have to be readjusted if your lucky, Get it check out before it gets worse, End does damage to the ...