1993 Ford Bronco "remove rotor" Questions

Remove the hub and rotor assembly. Install the rotor in the reverse order of removal, and adjust the wheel bearing as outlined in Section 1. F-Super Duty with 4-Wheel Disc Brakes The hub and rotor are

...rotor on( in the center under a cap w grease in it), remove these and it should come off. if its rusted on youll have to hammer it a bit. after you remove the tire and caliper youneed to remove the ...

nut, (5) remove the disc brake caliper (6) now pull on the rotor. It should slide off the axle. Reassemble in reverse order, being sure that the axle bearings are in place with proper amount of grease

...remove the caliper and caliper mount bracket (2 separate pieces) then knock the rotor off, you can smack it with a hammer but if you're reusing the rotors and are just turning them dont hit them ...

1993 ford bronco front rotor removal. do you have to remove the 4x4 hub assembly to remove the rotor? yes, you also need a specialty tool for the removal.

...Remove the outer bearing and then the hub 7. To separate the rotor from the hub, use a soft faced hammer to drive the studs out 8. Turn the hub over and set the new rotor in place. Put the studs back ...

...remove the caliper bracket, there are 2 bolts at the backside, then the rotro just slides off, clean any rust on the rotor mount area while the rotor is off, then using a large clamp depress the ...

...rotor, the earlier ones require you to remove the hub assembly inside and the bearing and such. If your just going to turn the rotors check to see if anyone around you does this with them still ...

...rotor before I remove the pads and pins. I think it takes a 1/2" socket for the pins. Now this is just part of your job. You said you wanted to remove the rotors I assume to have them turned or ...

i want to remove the hub and rotor as one piece its manual i don't think you can . you have to remove the hub to get to the nut that hold the bearings and rotor on to spindle.