2003 Chevrolet Malibu "blower motor relay letting" Questions

...blower fans are working. What should I look for? most fans don't come on until about 220 degrees so u might not letting motor get hot enough to turn fans on let it sit and idle for a good half hour ...

blower motor on 95 olds 88 stays on the blower motor for my digital ac and heat stays on even after turning off ignition. i was told it was the module i replaced it once it got hot same problem all i ...

blower motor keeps running when i turn car off. there is a stuck blower relay , it is located at the lower right underside of dash near the blower motor . find this relay and replace it .or stop by a ...

Blower Motor is fine and the Blower Motor Resistor that controls the Low to High speeds is bad. This is located behind the Glove Box in the Dash and on the firewall. Remove the Glove Box to access. It

blower motor relay located. Is it in the blower motor control module? Are there any hvac trouble codes ? Did you check voltage and ground for front blower motor, with controls turned on? I believe the

...blower motor is also ok...no power getting to the control knob which to me indicates the coil to the relay is not being energized and therefore the contacts will not close..therefor power can not get ...

...blower motor in the engine compartment. here is how your system works. The mode switch provides power to the blower relay. With the relay on, 12 volts goes from the relay to the blower motor. The ...

Blower motor stopped working Bad blower motor ? First unplug connector at blower motor , use test light to check for electric power is getting to it, if there's power to it. This will also eliminate ...

...Blower Motor or the Relay that is bad, but it is the Resistor which is located behind the Glove box. Follow step #a. below and take out the Glove Box to access. It has 3 to 4 wires going into it. The ...

...blower motor resistor, blower motor. You can check for power at the plug for the blower motor and back track from there. If you have power at the plug then you need to replace the blower. A cheap 12V ...