1997 Chevrolet Lumina "coolant water pipe metal" Questions

...water pump I believe they are 7mm. with the radiator cap off and the car running slowly open 1 bleeder at a time just crack it loose until you get a steady stream of coolant make sure to keep the ...

water will not circulate properly and cause the fans not to work. Anyways if the fan does not come on while unplugging the coolant sensor take a test light and check the wires going to the fans to see

...water jacket of your motor, it could be just a head gasket if you're lucky. Also check for a leak in the coolant pipes them selves usualy at the connections. Ken S. this is definitely the coolant ...

COOLANT HOSES NEAR THE WATER PUMP/ WHAT IS THE BLACKBOX ABOVE THE WATER PUMP ON 87 ACCORD LX? Yes, there is a "bypass outlet" coolant hose that connects from the water pump inlet pipe (metal pipe that

...water,not pipes not radiater not head gasket.there is a small metal pipe on bulkhead is this anything to do with heating If you are not seeing a coolant leak on the ground, and you are adding coolant ...

...water line in intake manifold even with correct coolant % modern day metal coolant pipes are a weak metal and can corrode or pin hole possible welsh plugs check the block has not got a hairline crack ...

...coolant entering the combustion chamber and boiling off during ignition. It is superheated water vapor (more than 212 degrees) and turns to visible steam as it cools when leaving the exhaust pipe. ...

...water pump has a metal pipe that goes to radiator.all new.metal pipe leakes.how do you stop leak? There should be rubber hoses at either end of the metal pipe to allow for engine ,movement. It would ...

...coolant pipe goes from behind water pump to thermostat how to change Replacement it when engine cold is better by steps below. - Remove Air filter - Remove intake duct - Remove thermostat housing. - ...

...water outlet pipe and thermostat housing connection. Will new thermostat gasket fix leak? Is it all one piece, the outlet pipe and the t-stat housing? The gasket goes on the bottom of the housing ...