1997 Chevrolet K1500 "cam" Questions

...the firing order...just wierd that everyother cylinder appears dead at idle.It does have a mild cam, could that have something to do with it. Thanks Carl yes that can and you might try a hotter ...

Code 1345 came up. I already replaced wires, plugs, cam, crank sensors. have you tried setting the cam sync.its basically setting the timing but without a timing light.you need a scan tool to do ...

...wearing teeth off how to stop this from happening do i need to shim distributor or is the cam possibly the problem 1997 chevy k1500 350 auto I would say if its happend more than once its a ...

...drivers side below dash] start the engine and bring the vehicle to operating temperture. Monitor cam ****** on scan tool. If cam ****** is between -2 degrees and +2 degrees the distributor is ...

96 gmc 1500 4x4 with vortec motor set timing on 96 gmc with out cam and crank sensor code coming on put in rebuilt motor with small modified cam 480 lift and 258 duration Timing is not adjustable. You

where are the cam & crank position sensors for a 1999 chevy suburbon 5.7? THE crank sensor is located at bottom of timing cover on front of engine if you look under engine below crank pulley ...

replaced crank and cam position sensor on 2007 chevrolet 5.3l silverado 1500 ltz. cleared up code for crank position sensor now code p0340 for cam position sensor circuit is showing up. dont have a ...

i have a 97 chevy z71 it has a 5.7 vortec i replaced the distributor and cam shaft position sensor and it is running rough...i know i timed it right ...it was top dead center...any suggestions The ...

...on, the truck runs great and has a small delay when starrted.. what can/do i need to??? 1345 is cam and crank sensor correlation its mainly the cam sensor going out, also the delay start that

...the mark on the back of the dist. to line it back up. I know if you get a little off it will set a cam and crank sensor out of calibration. is there a way to set it without setting a code.I have