...97 chevy z71 it has a 5.7 vortec i replaced the distributor and cam shaft position sensor and it is running rough...i know i timed it right ...it was top dead center...any suggestions The timing cant ...
97 4.3 vortec ? did not mark distributor when I took it out bring up number 1 piston by taking out the spark plug and use a screw driver to feel the piston come up then check the marks on the crank to
97 GMC jimmy with a 4.3 vortec with is a v6 4 speed automatic transmission 188,568 on the odometer and when I drive at about 60 and it fills like it surging for gas but when u give it gas it will stop
...vortec I've pulled off all the wires and checked for a spark all but #5 sparks i changed the wire set and have the same problem. the truck starts and idels fine but try to accelerate and the engine ...
97 and 98s, Vortec engine is that the gears were soft and they would actualy wear enough to through off the timing and you could try to adjust the timing but at some point you'll run out of adjustment
...97 S-10 with a 4.3L. I just put an engine in it and it is hard starting and when cranking pauses in between cranks sometimes. Once started, it runs pretty smooth but when you bring the idle up, the ...
...vortec. why dose the harmonic balencer have 2 timing marks on it & what one do you set the timing from? thanks The reason there are two timing marks on the balancer is because you can line up the ...
97 GMC Safari w/ 4.3(W) V6 vortec. 195k miles. Engine is running very rich. 10mpg. Smell of gas sometimes coming from exhaust when running. It has rough idle, and dies, especially when cold. Lacks ...
97 K1500 5.7 vortec. It cranks and fires on what sounds like only one cylider. The fuel pressure is 50psi. The distributor was checked and installed by placing on #1tdc, then putting the rotor on the
1,105 questions posted
Usually answered in minutes!
878 Questions
795 Questions
575 Questions
561 Questions
414 Questions