1994 Chevrolet S-10 "throttle" Questions

looking for the throttle position sensor You didn't indicate which engine, but regardless, it is bolted onto the throttle body on the opposite side of where the throttle cables attach. It is ...

Throttle stuck wide open It starts and runs fine but when I give it gas it sounds like the throttle is wide open. Sounds like it would if I put the gas to the floor but it accelerates normally just ...

...problem with my Chevy s10 2.2 about this high idle , already replaced iac two vacuum hoses and one throttle body and still my rpms are at 1500 in gear 2000 in park or neutral if anybody can help me

...IT IS IDLING TO LOW.AFTER WARM UP IT HAS A HIGH IDLE AND SEEMS LIKE THE CHOCK IS STUCK. ? IT HAS A THROTTLE BODY.ITS A 4.3 LITRE. HELP sometimes the gasket under the trottle body goes bad. spray

...plug? You could have a dirty EGR valve, you can re move it from the manifold and clean it with Throttle body cleaner. Might as well buy two cans, since your cleaning the EGR, might as well clean ...

...I accelerate. Try replacing your spark-plugs/wires, cap/rotor, air-filter. Spray some WD-40 on the throttle-body recoil spring.Get a can of carburettor/throttle-body cleaner and spray the inside of ...

Throttlebody, injectors pouring gas instead of spaying , truck will start for seconds till gas pours & floods. I've replaced injectors put kit in fuel presure regulator,set #1 pistom up,timing

engine wont fire until fuel is poured in throttle body when engine warms up it will not idle and dies then fuel must be poured in throttle body to start it. fuel must be poured in to start when cold ...

...pickup throtle to go to 1500-2000 rpm and stay there in any gear ????? Sounds like the the TPS...(throttle position sensor)..You can replace it your self. Refine the search to your particular ...

...leaking. two spots , Governor cover and from some sort of cable going from the transmission to the throttle body The govenor cover has an o-ring seal. No problem, just be sure NOT to let the govenor ...