1994 Chevrolet K1500 "spark" Questions

why is there no spark from spark plug 1995 k1500 silveraldo 1995 silverado has a distributor, remove the the distributor cap, make sure the distributor spins with the engine. also make sure the ...

...hav an 88 chev half ton with a 350 turns over an its gettn gas to the throttel body but wont run no spark, spark advance's are not connected or bad timeing is my guess. take a plug wire off put a ...

what is the proper spark plug gap for a 1990 Chev K1500? Usually tighten the spark plug to avoid generator combustion vapor excape because the vehicle speed may reduce. Alternately, the vehicle ...

1984 chevy p/u with 305 no spark rebuilt dist & changed EST Module & still no spark to spark plugs what else can cause no spark? computer coil power try to disconet the spout wire..... its under the ...

I replaced my spark plug wires on my 1996 chevy truck. may have crossed one,need a diagram from the spark plugs to the distributer cap. Since you didn't state whether it is a V6 or V8, I'll give you ...

...hope this tip helps. R/ David Check the Main Relay and fuse. look at engine in the dark for extra sparks listen to sparks on the am radio, sparks missing or the engine sputtering rev the engine a ...

...pump and started, and fuel filter. It still won't start. It turns over but acts like there is no spark. I changed the plugs, wires, distributor cap and rotor about 10,000 miles ago. I don't know ...

...at switch is normal 1 volt.Voltage drop at battery is 2 volts.Where do I check next? do you have spark at the plugs? if you do spray some starting fluid in the carb see if it wants to start if it ...

...it feels as if not all of the cylinders are firing. in park it has a rough idle and i have noticed sparks down below the steering pump on what i assume is the frame. Your description of sparks at

spark to distributor from coil, no spark coming from plug wires, replaced ignition module, no help Hello Nummy. If you have spark at the coil the module is OK. The module fires the coil. Your problem ...