...bulb, tail light circuit board, and tried a flasher from another Chevy truck that I know was working and still there was no change. What could it be? It could be a bad multifunction (turn signal) ...
...light relay and ensure this is switching when the pedal is pressed down, you should feel it or hear in click. hope this helps, let me know how you get on. Jason FYI `````` Contact GM.., there is a ...
...bulb or socket problem. They sound like they're not getting power and, if the fuse is good, a connector is probably loose or unplugged. Good luck. Should be the brake light switch its located ...
...94 s10 blazer is located under the cluster area right behind the panel that holds the parking brake release handle you will see it once a couple of trim panels get remove it will be to the right side ...
...light up then you know it is an electrical problem in the wiring and will have to trouble shoot that. This sounds like it MAY be what is a fairly common problem with these models.The turn signal ...
...light is still working. Instead, check in the trunk of your car. Can you see a wiring loom there? It is usually hidden under the trim. Look for a disconnected or loose plug. If it is not that, then ...
Question about Cars & Trucks
...light should be flashing. if CEL lamp bulb is dead,it must be replaced.in IP cluster The code(s) stored in memory may be read through counting the flashes of the dashboard warning lamp. The dash ...
...bulb still will not light, or if it does not flash with the test terminal grounded, the system should be diagnosed by an experienced driveability technician. If the light is OK, proceed as follows. ...
Question about Chevrolet 1500
...out on my 94 chevy beretta. I can push it and it will come back on. However, it keeps going out as soon as I put the bulb back in the tail light. Does anyone have any suggestions? replace the ...
789 questions posted
Usually answered in minutes!
878 Questions
795 Questions
754 Questions
575 Questions
561 Questions