1994 Chevrolet K1500 "43 knock" Questions

...knock isssue code 43 throttle position sensor out of adjustment.not working.if you replace knock sensor and it still spark knocking.make sure the wire connector is not broken.go to higher octane gas ...

...43 Knock Sensor (KS) Circuit probable cause is Signal to PCM has remained low for too long or the system has failed a functional check. I wish you luck with that repair. code 43 indicates a knock ...

...43. We replaced the knock sensor and plug to it. At time lamp is out and starts fine others it will crank a lot before start and lamp comes on Code 43 has different meanings.It has to do with the ...

...43. Can someone offer me some good advice on what i can do to get rid of this code? As much money as you have spent, you could have fixed it and had a lot of beer money left. First thing to check is ...

where is the knock sensor on a 1994 Chevy 350 engine located? I have cide error DTC 43 I believe its located rt side rear. just a little lower where head seperates from block..

...43 problems I no it could be a bad knock sensor. My problem is I had headers put on . They were a tight fit in the area of the sensor, I did not do the work. The sensor is screwed in to a 90 degree ...

...43 is the knock sencor so I replaced the knock sencor but I still have the code 43 evan after clearing the code any input will help. Check for a 5 volt reference signal at the wiring to the knock ...

...43 is electronic spark control. ESC module is not receiving a knock signal from knock sensor. Check knock sensor/wiring, check ESC (parts store can check for you). That's what the book says to do. On ...

...43 may be a problem with the knock sensor. Code 43 can set when the knock sensor is functioning correctly too. You would need to get the troubleshooting charts for the codes to determine the

...grand prix 3.1 computer code 43 engine code 43 - electronic spart timing problem- possible knock sensor problem.. check for 5v at knock sensor wire.. if it has 5v then probably need a knock