1998 GMC Sierra "wiper motor" Questions

...retaining nut that holds the arms to the back of the wiper motor. Disconnect the wire connector then remove the 3 bolts that hold the wiper motor to the fire wall. Reverse order to install new

...wiper motor was replaced. The wiper drive shafts are keyed NOT just splined. How do I time them. When you turn them on, they go down first then up. Driving me crazy. Put the wipers down near the ...

...wiper motor control module needs replacing. On some models you can replace the "pulse board". On some you must replace the wiper control module which mounts directly to the windshield wiper motor. ...

...wiper motor but i also found that the wiper fluid wont work either. I checked the fuse but it is still good. Could it be the control board? Check if there is power at the wiper plug, make sure the ...

...wiper motor but that was not the problem. did you try to direct your new motor to the battery only?....if you direct its fast that means your rod to the wiper are rusty or dirty try to spray some oil ...

...the windshield wipers on a 1996 GMC truck. I replaced the wiper motor and the wipers will not lay at the bottom of the windshield I just take the arm off and reposition the arm in the splined

...whenever I turn on the switch. Replaced wiper/cruise control arm. Fuse blew. Disconnected wiring harness from wiper motor and turned on switch. Fuse still blew. You have a short in the wiper ...

...wiper motor on the fire wall there is ablack plastic cover over the motor remove that and you will see a chip board that is replacable its usually around $20 or so, which is cheap way to find out if ...

wipers work on high only with a new wiper motor just replaced motor on windshield wipers and they only work on high, not low or intermitant Try checking the wiper switch

...wiper motor. sounds to me like your motor is going out the solnoid is shorting out but to answer your question yes it could be but i think and have had experance with tis before i really think it is ...