1998 GMC Sierra "replace cranking sensor" Questions

Ad

Question about GMC Sierra

2 Answers

...is the distributor gear which is what mine was. It's quite common. The gear is about $60 and can be replaced in less than an hour with the right experience. The engine won't usually run if it's the ...

Ad

...brush or rub, spray wash with cleaner. no compressed air. It dries quicklt. Coolant sensor must be replaced if bad. Coolant and intake air sesors set up the cold start like a choke. The maf sensor ...

Ad

Question about GMC Sierra

1 Answer

2004 sierra 5.3 cranks no spark just replaced starter ran before replacing starter also replaced crank location sensor Did you check primary voltage at the ignition coil, pink wire, goes hot with key ...

...replace the crankshaft sensor. no it will not stop spark,most likely cause is the crank pick up sensor Fuel pressure and spark are 2 different things. one thing that can cause no spark is the ...

trouble code 1345 crank sensor/camshaft sensor correlation On a 1998 GMC sierra, I Have replaced the heads, timing chain, done a tune up, also I replaced the crank sensor, on the advice of someone ...

Question about GMC Sierra

2 Answers

...what have ya it ended up being the cam positioning sensor located under the distributer cap remove the cap and rotor then you can pull the part and replace it started right up runs like a ...

I have a 90 GMC Sierra, 5.7 ltr, 2 wheel drive, 1/2 ton. I recently replaced the ESC module ,MAP sensor, and TPS, because they coded out... I also replaced the distibutor as well. I was running well ...

Question about GMC Sierra

2 Answers

starts but doesn't stay running Replaced timing chain and crank shaft sensor. Engine will start right up but won't stay running longer than a few seconds. Is it maintaining good fuel pressure? did u ...

I have a 1997 Gmc Sierra 5.7 4x4. It has no spark. I replaced the coil and ign module today but still no spark. Tech suggested Crank shaft sensor? Truck was running then died going down road. (30kms ...

02 gmc 4.8 code po336 i replaced the sensor but still won;t start try replacing the oil pressure switch on the back of the block. If IT DOES NOT DETECT OIL PRESSURE IT WILL NOT RUN Kills the fuel pump

Not finding what you are looking for?
1998 GMC Sierra Logo

1,551 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1997 GMC Sierra
1997 GMC Sierra

847 Questions

2000 GMC Sierra
2000 GMC Sierra

676 Questions

1999 GMC Sierra
1999 GMC Sierra

601 Questions

1994 GMC Sierra
1994 GMC Sierra

604 Questions

1996 GMC Sierra
1996 GMC Sierra

457 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...