1997 GMC Sierra "tilt wheel stuck position whats" Questions

...stuck in its bore. Not likely, but now is the time to check. 4. Rotate the carrier so that the cross shaft is tilted up at the front, down at the back with the rear/lower end being the end that was ...

...wheel won't tilt. What's wrong? Tilt steering wheel won't tilt. It's locked into the upright position and the lever to move it up and down will only go half way up? What could be the problem? your ...

...wheel left to right or tilt steering if has tilt to windshield turn key I assume you mean in the ignition. As your trying to unlock the key by turning it, attempt to turn the steering wheel back and ...

...wheel stuck in up position,and won't adjust down, whats the problem? the release for the tilt mechanisum is made of pot metal and had cracked apart causing this to happen. Any GM dealer can order ...

...the seat for fine tuning). Once done, and every thing is put back together, disconnect the motor cord cause the wheel will be able to tilt, but will get stuck again once it hits the gap in the

...tilt wheel models that get the tilt feature used regularly. the wires get jerked out or the switch with the wheel tited up does the problem go away? The other is the switch itself with someone ...

...tilt the bed up on the drivers side, remove the four bolts on the drivers side and loosen them on the passengers side. Using a hydraulic jack and several lengths of 4x4 and 2x6x6 blocks, carefully ...

...stuck on a grate on the ditch. i could tell when it was being pulled out that some damage was being done because the wheel was tilting in a position that it shouldnt have been forced into. i took it ...

wheel and applyed the parking brak thinking it might be something like that. the inside lights come on when you slide the key into the switch but it just won't turn at all. I am afraid of breaking the

Tilt your steering wheel up and you will see a small round hole under bthe steering column , use something like a pencil or a nail and insert it into the opening and push it in keep it pushed in while