1997 GMC Sierra "gear head 2 8mm" Questions

...head, and then there is a 2" long (or so) unthreaded smaller diameter section which extends down beyond the threads. This is what goes through the cross shaft and retains it. 3. Tap the cross shaft ...

...timming gears there is 8mm holes that line up 2 the same size holes in the head, stick a 8mm bolt through to alighn cams, the crank marck pionts staight up. you might have the gears on the wrong

ONE OF THE ENDS OF THAT PIN OPOSIT OF RING GEAR THERES AN 8mm SMALL HEAD BOLT ( TURN RING GEAR TO CHECK OTHER END OF PIN ) REMOVE BOLT PUSH AXLE IN REMOVE HORSE SHOES CLIP IN 3rd MEMBER SLIDE AXLE OUT

gear shifter boot for my 4 wheel drive and in doing so realized my shifter itself isn't attached (not the knob the stick). It pulled right out and there was a whole in the bottom of it with no bolt or

...gear switch, speedo cable. 10.Remove the two bell housing bolts on the top (next to the cylinder head). Take one bolt to a local tools and hardware and source the exact thread bolt but buy bolts that ...

...gear, idle drops to engine stall. 1998 Navigator 5.4L. If it is the same engine design as the F-150 ( think the '98 was still the 2V V-8 ) it could be the IAC ( Idle Air Control ) is gummed up. The ...

...head new turbo the problem was my sprocket gear on da pump has no mark van starts but smokes a lot no power n long to start so I no its the pump timg that is of Images for 2.5 ranger td 2007 diesel ...

...gear has a arrow on it, and the cylinder head has a small dot. Align the arrow with dot, and make sure it is aligned (the arrow must point up). The crank gear has a notch and the engine has a groove ...

...head gaskets. To install the distributor drive shaft, dab some grease on the top side of the gear to hold it in place, and line it up with the distributor. If you are having trouble lining up the ...

...head bolts only not the 17mm bolt in the center.) remove the metal plate behind the engine mount bracket on the engine, remove the plastic timing belt cover 3 clips on top 2 10mm bolts on bottom. ...