2003 GMC Sierra 2500HD "focus rear bearing replacement" Questions

focus If you have rear drums on your focus then chances are you just need to remove the dust shield (metal cap covering nut) and remove the 30mm nut on the end of the knuckle. at that point you may as

...focus. remove the hub and spinle ,tie rod end ,axle nut.ball joint,and seperate from strut and then have new bearing pressed in...or rent a bearing press that works with an impact wrench,but they are ...

...is the abs ring on the ford focus rear drums????? does it look like an oil seal on the on the bearing The ABS reluctor is built into the rear wheel bearing assembly, and it must be replaced as a

how do i replace the rear wheel bearings? replacing the rear wheel bearings There are 4 bolts on the back side to remove the assembly and then you have to have a press to remove the bearings from the ...

...Focus? its a hub style wheel bearing, you need a slide hammer to take the bearing off. also make sure you take the snap - ring off. there is a few different ways you can tackle this, depending on ...

rear near side, garage supposedly changed the wheel bearing, no joy. Replaced tyres at garage advice, still no joy. did they check the other wheel bearings? some time a wheel bearing noise will travel

...rear drums out of a 2002 ford focus zx3 i took out the four nuts in the middle of drum and still didnt come out You may have to loosen the brake shoes. And also "bang" on the drum with a small sledge ...

rear brakes 2000 ford focus zts my bearings were going out on my focus, i purchased two new drums with bearings already in them ,had to force one on the on the second one i realized that the self ...

rear wheel bearing on focus cmax If you have drum brakes like my Focus sedan, It is very easy. It is a sealed unit that just slips in. You may have to coerce the old on off, but it does not take a lot