2003 GMC Sierra 1500 "transfer case disassembly" Questions

this a problem, thanks Stan Yes it is a problem. There is a new design clip. The case needs to be disassembled, repaired and the new clip needs to be installed, or you will burn out your transfer case

...Transfer Case - NVG 149-NP (One Speed Automatic) - SUV 2004 TRANSMISSION Transfer Case - NVG 149-NP (One Speed Automatic) - SUV TRANSFER CASE NO FRONT DRIVE Transfer Case No Front Drive Cause ...

transfer case Have not started to disassemble the case because I am not sure as to where I need to start. the best place to start is with the purchase of the workshop manual as it is difficult to work

...transfer case, could see and hear it move in extension housing. is there a bearing that could be worn out? 200,000 plus on it You need to pull the Transfer Case & completely disassemble it & ...

transfer case will not engage four wheel drive in my 97 ford supercab f250 Here are a couple of solution you may try: (1)-Transfer case not fully engaged. Stop the vehicle, shift into neutral and then

...transfer case, It's a couple hundred dollar part tho. See if you can hear it run when you shift it in. It's right on the transfer case. Could even take it off and turn the shaft by hand to get the ...

transfer case in this era were notorious for freezing up over time. You can normally remove the motor from the transfer case, disassemble, clean the motor contacts and reassemble. The shifter motor is

...transfer case problems the transfer case blew apart. have replaced the tranfer case, without reattaching the front drive shaft. when you take the jeep for a drive it only goes 25mph and 2500 rpms; it ...

...transfer case, while your helper in the truck pushes the buttons in 2 wheel and 4 wheel back and forth until it slides in it's slots. If you miss it and the encoder quits working then you'll have to ...

...transfer case When replacing the transfer case( which I was sure was the problem) I found one whole side of the overdrive unit cracked (2 pieces); so no what ? Replace the whole tranny? Or, try and ...