2006 denali scm I've replaced the front shocks on my 2006 and still have the service ride control message what to do? Have you reset the ecm with a scan tool? Just changing the parts wont clear ...
...ecm continues to tell me that the passenger door is open although it is closed. Is there a sensor that is not operating that I can change or reprogram? Check the door switch, if that is ok you may ...
...change the oil. This is a warning light that is illuminated when there is a problem affecting the Emission system and the engines computer management (ECM) has detected it from a fault. It could be ...
...on and i went to change the old ecm and now there is no power to the new ecm Did you disconnect the negative battery cable before changing ECM? check ECM fuse, why did you change ECM in first
Question about Honda Cars & Trucks
change ecm no program is required ex if u have a four cyl and u installed a 6 cyl u need new ecm that wont match including the wiring and ecm that would have to be programed to match bcm body computer
Question about Cars & Trucks
...stated items it could be a problem ECM if it happened after a ECM was changed to test change with a new or known ECM and if there is not results then run the fault codes and look for the VSS ...
Question about Cars & Trucks
...but car won't start gx470 what could be the problem change the ECM, change the immobilizer settings for the key try a scan tool to reset the ecm other than that the ECM may not have been the ...
Question about GMC Yukon Denali
change the ecm to a 2010 no...check your fuses The ECM and engine are matched - if you changed the ECM when you changed the engine, that may work. However, if you didn't, your ECM is probably confused
...CHANGE ECM SOME LOCKSMITH TOLD ME NEED TO CHANGE THE IMOBILIZER BOX? WHERE IS THAT BOX? Part number of the ECM is required to know the location of Immo box. Mostly the ECM in 2005-2007 was integrated ...
...gauge ? Check you fuel pump relay. located on IPDM marked as ECM relay in the picture. Just change places of ECM RELAY and FOG LAMP relay and try to start. If it starts change the ECM relay. good ...
296 questions posted
Usually answered in minutes!
561 Questions
369 Questions
253 Questions
170 Questions
162 Questions