Question about GMC Suburban
...oil pressure guage sending unit located on 1999 GMC suburban 5.7l vortec motor? I can't locate the oil pressure sending unit to replace it. I've looked all over but can't seem ...
...oil pressure sensor or a bad oil pressure control valve which is located at the engine block where the remote oil filer line connects to. Start with the simple and replace the oil pressure sending ...
oil pressure sending unit? where is the oil pressure sending unit on a 1996 GMC 4WD Suburban? The oil pressure sending unit is located on the engine block, passenger side by the Distributor. Good luck
...Oil pressure gauge bounces back and forth between 40 and 50 pounds very rapidly Replace the oil pressure sensor located near the oil filter. When this part starts to fail you will see your oil ...
...Oil pressure should be around 30 at idle and then sit at 60 when engine is above 2,000 RPM. If pressure varies at all engine speeds it indicates a sticking pressure relief valve which is located ...
...oil pressure sending unit on a 2005 4X4 Suburban 1500 5.3 liter Removal & Installation4.8L, 5.3L & 6.0L EngineTo Remove: Remove the engine sight shield. Disconnect the oil pressure sensor ...
oil pressure pegged to right even when off Defective oil pressure sensor located on the engine block.
oil pressure sending unit on 97 gmc yukon location Oil pressure switch. back of engine on top below ignition distributor.
...oil pressure sending unit 5.3 liter? It is located on the very back of the engine closest to the firewall. It will be to the right and below the I take plenum ( as your standing in front of the ...
...oil pressure is a bit low by the time it gets to the lifters of the lifters could be getting tired. This engine has a roller camshaft and lifters. Does it make lifter noise or are you just asking ...
336 questions posted
Usually answered in minutes!
921 Questions
273 Questions
225 Questions
157 Questions
68 Questions