...slave cylinder. it has been doin fine but when you shift towards reverse it slips into 4th and now fifth is out to. when you put it into 1st through 4th it moves side to side like neutral It sounds ...
Question about Jeep Cars & Trucks
...cylinder, slave cylinder and connecting line are serviced as an assembly only. The linkage components cannot be overhauled or serviced separately. The cylinders and connecting line are sealed units. ...
Question about Dodge Cars & Trucks
...slave cylinder could be going bad IT could be the slave cylinder or the clutch master cylinder check for fluid leaks at the slave cylinder and if ok replace the master cylinder if after checking and ...
...slave cylinder, make sure it good working operations. worn rubber seal inside slave cylinder will cause a blow-by when press down the pedal therefore, causing to have a weak clutch ...
Question about GMC C1500
...slave cylinder assembly. Autozone carries 2 of these part numbers (12596) for $47.99 and (LSC003) for $84.99. Don't foget to change the pilot bushing also. It's $3.99. It's located in the back of the ...
...slave cylinder. I've even heard if as simple a problem as the bolts holding the slave clynider coming loose, so when you press the clutch, the slave actually moves. If you're having troubles getting ...
no pressure in clutch system It sounds like you replaced the slave cylinder. It could be master cylinder or clutch pedal bushings? --------------Multi-Di@g Access J2534
...bushing,it is most likely worn out,maybe gone,this will lift the pedal more than you think,are you having problems going in gear with the engine running?Also,bleed the system at the slave
...slave cylinder failure , slave is plastic and the ears and white coller snap off, when cold if your car feels like its jerking as you move off i would deffently say it is the clutch arm and not the ...
slave cylinder...Problem: before I bled the system the clutch pedal when depressed would reach nuetral safety switch after bled it now will not reach nuetral safety switch..help? Check the bushings in
94 questions posted
Usually answered in minutes!
421 Questions
77 Questions
67 Questions
59 Questions
36 Questions