1995 Dodge Dakota "throttle body adjustment 3" Questions

...throttle body with throttlebody cleaner? 2 or 3 torx screws normally holding it on . Remove it, clean pintle (pointed end) and shaft with cleaner, and re-install and try that. if it cures it for a ...

...Throttle Body Failures - YouTube ? 3:26 www.youtube.com/watch?v=FDpUo3UPmto Jan 10, 2014 - Uploaded by FordTechMakuloco Just to say I had a 2006 five hundred and cleaned that throttle at 98k, and ...

...throttle body position sensor. In some mazda vehicles (IN TRINIDAD) you need to loosen the throttle body position sensor and slightle adjust it eighter to the right or left to tuen the idle (For ...

...throttle body with tb cleaner. I then replaced the throttle body but my idle is still too high. Is there any way to adjust the idle? No..you can't adjust the idle... Possible cause---Electric ...

...throttle body and inspect for any black sutty build up aroung throttle plate. Where is the intake tube located... .#2 a faulty Idle Air Control motor. This part is an electronic idle adjuster to alow ...

...throttle body base manifold area clean out throttle body also if carboned up is also possible this idle air control valve (IAC) is sticky due to carbon build up clean with carby cleaner or some sort ...

...throttle body. Known by both names, Automatic idle speed motor (AIS) Idle Air control (IAC) . Usually mounted on side of throttle body, with 2 or 3 torx screws and it's job is to adjust idle at all ...

throttle valve body,cleaning with electrical or MAF solvent and reassembly install, how does adjustable IAC screw figure in obtaining proper idle speed after setting throttle cable free side play to 3

...throttle body. It is held on with 2 screws and has a 3 wire electrical harness plugged into it. The easy way to locate the throttle body [in case your brother does not know] is to follow the black ...

...throttle body for ease of installation and adjustment Fig. 4: Remove the sensor retainer screws Fig. 5: Lift off the throttle position sensor Disconnect the negative battery cable. Disconnect the ...