1995 Dodge Dakota "1998 2 cranks" Questions

1998 5.2L HAD LONG TERM DEAD BATTERY , WON'T START pRIOR TO SETTING IT HAD A PROBLEM IDLING OR WHEN LETTING OFF THE GAS, it would either stall or stumble. The battery went dead for a couple of months ...

...1998 dodge Dakota It is located around the crank pulley. It will have 2 to 3 wires going to it. That will be the only wires that will be located around the crank pulley. It is attached to the block ...

1998 dodge dakota 3.9 runs great for about 10 min. than starts to miss and backfire no check engine light has had cap,rotor,plugs,plug wires,coil,cam senser,crank senser,tps,cat.,#2 o2 senser and pcm ...

NO Start the truck is not getting spark the coil is good but i'm not getting any power to the coil and I need to know if i'm testing it right i'm thinking it is the ignition THE POWER TO THE IGNITION ...

right hand motor mount in way of freeze plug Jack the engine up,use a jack,and a thick piece of wood,and put it under the crank pulley,remove he pin-bolt from the mount,and jack the engine up,make ...

Crank shaft movement 98 Dakota with V6 83000 .miles crank shaft is moving back and forth causing the belt to squall what would cause this did you check the pulley on the crank shaft ?? is it warped ??

...cranks runs fine shut it off wont start back up wait a while it crank can drive it every now and then it will back fire changed coil pickup in dist wires got good fuel preasure changed relays run for ...

1998 ford Explorer starting 98 ford Explorer starts off cranking like the battery is low but then it keeps cranking faster until it starts which take about 2 to 3 minutes check your ground cables for ...

1998 ford couier ute wont start it must crank fast or no car starts. mine push starts and gravity starts. does crank,,, look at crank shaft of car (front pulley) is it spinning fast as person 2 cranks

...1998 saturn sl 2 car starts after 5 or 6 i have 1998 saturn sl 2 car starts after 5 or 6 cranks just replaced starter,alternater and battery so none of these are the problem .help please Spray ether ...