1998 Mazda B-Series "change clutch slave cylinder 98" Questions

...is leaking and to replace it you will need to remove transmission from vehicle. while your there you should change the clutch because it is out. unless it was just change then just the slave. good ...

...change gears if I push really hard on the clutch. What is wrong? check the hydrolic fluid for the clutch you need to do some checks(1) check clutch master cylinder container if fluid level is ok if ...

...clutch master cylinder and the slave cylinder ive pumped the oil back into the system from the nipple on the slave cylinder until the oil came up into the brake master cylinder my problem is that the ...

...to turn it over. Is there a easy fix for this? Changed clutch, throwout, pilot bearing and rear seal. did you get your slave cylinder blead? does the tranny disengage when you push in the

...clutch won't enagage gear on my 98 corrola at low speed. I cannot change gear sometimes and car will stall. This has only just started happening, Can you tell me what the problem is? My clutch also ...

...clutch wont engage gears on my 98 corrola at low speed or at idle. I also cannot change gear. This has only just started. Can you tell me what the problem is? The clutch also felt spongy as i tested ...

...change the seals on a clutch master cylinder fit a 98 Subaru outback You are wasting your time refitting the seals, just replace it. Go here for great prices on all parts and best quality. ...

...clutch master or slave cylinder is leaking or is low on fluid. The "unusual resistance" is more of a concern. Have your garage check the clutch hydraulics, and also verify that the transmission to ...