...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...
how to remove the starter on mazda mx-6 gt, can it be done w/o removing the intake manifold? yes but you do have to pull the brace that connects to intake ,exaust ,an trans.
...intake manifold bracket. Label and disconnect the wiring at the starter. Remove the starter mounting bolts and remove the starter. Installation is the reverse of the removal procedure. Tighten the ...
...intake manifold. Initially, disconnect the battery/cable; next disconnect the start wire. Thereafter, remove the two (2) bolts for the intake manifold support bracket and remove the bracket. Remove ...
I got a question where is the starter located at in 93 Mazda Mx6 4 cylinder underneath the intake manifold
...car out in first gear but in all other gears can only rev to 4000 and then i here beeping and the car loses all power but still runs perhaps it is the knock sensor? situated below the intake
...manifold could that be where the water is comming from I guess it would depend on how much water and is it clear.The engine can have condensation until you start it and warm it up, which would be a ...
...intake manifold.we repalced the gaskets and plugged everything up to where they go. i also bought new spark plugs, plug wires,distributor cap and rotor. we got the car to idle normal with all ...
intake manifold, valve covers (pcv valve), and be sure to check for a vacuum fitting on top of the intake just behind the throttle body. Does it fit tight in the hole? You can seal loose fittings with
66 questions posted
Usually answered in minutes!
132 Questions
87 Questions
81 Questions
59 Questions
40 Questions