1991 GMC Sierra "sending unit working temperature" Questions

working This can be a simple loose connection or your fuel sending unit is bad which is located in the tank. the coolant temperature sender is usually located on the cylinder head or by the thermostat

...sending unit for the computer is not working correctly. ( not the sending unit for the gage, there are two). If the computer never knows that the engine warms up, it will keep "choking" and over ...

...temperature vs. resistance values If the engine seems to run OK, and no Check Engine Light, The sender unit for the gauge (separate sensor) may be bad. On most 4.3L engines, it is located on the ...

...unit. hi, the code means that ur MAF sensor is not working right, so ur trucks ECM is getting wrong information about air intake mass, temperature and humidity, thats why ur gases are wrong, because ...

...sending unit. Using an ohmmeter, measure the resistance between the terminal and the sending unit's metal body Infinite resistance or zero resistance: the sending unit is bad, replace the sender with ...

...sending unit on the engine, it sends the signal to the dash. check the temperature unit to see if it is working, if it is the gauge in the dash stopped working... These should both be covered under ...

...sending unit on the engine or a wiring problem. Try this: find the sending unit on the engine and pull the wire off it. With the ignition key on, touch the wire to a metal ground on the engine. Does ...

...dash is not working therefore reads cold all the time. Replaced the temperature sending unit and it is getting power to the sending unit. thermastat is good. there is a chance the cable could be ...

sending unit located? The temperature gauge sending unit is located in the front section of the intake manifold, just to the right of the alternator on the 4.6L engines. Got this from autozones repair

sending unit on a 2015 Malibu LT ecotec Interior dash temperature gauge not working. All other gauges are working as is the AC/Heat with no over heating. There was no code it just showed up three days