...sensor. Apply transmission oil to a new O-ring and install it on a new vehicle speedometer sensor. Install the vehicle speedometer sensor. Tightening torque 69.5 - 95.4 inch lbs. Connect the vehicle ...
...sensor electrical connector Manual Transmission To Remove: Remove or disconnect the following: Vehicle Speed Sensor (VSS) electrical connector. Retaining pin. VSS. To Install: Install or connect the ...
sensor to the transmission case.3. Remove the line pressure sensor from the transmission case.INSTALLATION1. Install the line pressure sensor into the transmission case.2. Install the bolt to hold the
...sensor. Remove the transmission from the vehicle. Remove the flywheel or the flex plate from the crankshaft. Remove the 2 bolts (3) and the sensor wire harness clips or shield. Remove the bolt (4) ...
...installing the pressure sensor and solenoid in the governor body, replace O-ring seals, clean the gasket surfaces and replace gasket. Place gasket in position on back of governor body Place governor ...
...sensor on the transmission or some where else. Yes, I would start at the speed sensor on the transmission called the VSS (Vehicle Speed Sensor). Also, are the tires the right size for the vehicle as ...
sensor off of the transmission case. To install: Position the TR sensor against the transmission case and loosely install the 2 retaining screws. Attach the TR sensor electrical harness connector. Use
...sensor electrical connector. 7. Install the transmission cover. Tighten the bolts to 12 Nm (106 inch lbs). 8. Install the starter. Refer to Starter Motor Replacement in Starting and Charging. 9. ...
Question about Nissan Cars & Trucks
...Transmission Range Sensor, also known as the Neutral Safety Switch. This sensor is located on the transmission and is responsible for telling the vehicle's computer what gear the transmission is in, ...
Question about GMC K3500
transmission or the shifting pattern? replaced ecm but still backfiring, popping, jerking and dying. Idles fine but will not run normally. Probably not the ecm.. look for bad plug wires, vacuum leaks,
12 questions posted
Usually answered in minutes!
27 Questions
25 Questions
18 Questions
21 Questions
15 Questions