...tighten the lug nuts in a star pattern. Check the brake fluid add some if needed, replace the brake fluid cap and pump the brakes until the the brakes are firm, start the car pump the brakes a couple ...
...tighten the axle nut to snug and replace the wheel, remove the jack stand and lower the car to the ground. 19) torque the axle nut to specs 20) replace the axle shaft cotter pin and axle nut cap 21) ...
...tighten them up. Put the tire back on (don't forget to torque the lug nuts to specs, I think Pontiac is 100ft/lbs.) Just repeat the process on the other side and don't forget to put the cap back on ...
Question about Pontiac Grand Am
...spring washer the lug should have a long cylinder shape on one end that is tapered to tighten up the wheel the washers hold the plastic hubs in place you might try a wrecking yard or a dealer for ...
...tighten lug nuts by skipping them. In other words start with one and tighten it, skip the next one and tighten the third one. When you go all the way around, go to the ones you skipped and tighten ...
Question about Cars & Trucks
...tighten the nut. Install the three upper strut nuts in the engine compartment and tighten them. Cover the nuts with grommets. Place the wheel on the Audi and tighten the lug nuts with the lug
...covers on tighten by hand until they're snug don't over tighten them you can srtip the plastic threads (note: the actual lug steel lug nuts are under the wheel covers make sure you tighten them good
...tighten the lug nuts so that the wheel sits flush against the wheel hub. Installation is the reverse of removal.15Lower the Sentra to the ground and set the dial on a torque wrench to 100 lb-ft. ...
...this process for each additional rotor and then lower the vehicle. Tighten the lug nuts and test drive your Dodge Ram to make sure that the installation was successful. If I've helped, please
...lug nuts, tire and wheel. Release the parking brake. Pull the brake drum from the hub. If difficult to remove try the following: Strike the face of the drum with a plastic or rubber mallet. This will ...
2,020 questions posted
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,208 Questions
1,285 Questions