2000 Pontiac Grand Am GT "resistor" Questions

...4 AND 5 AND NOTHING ON1-3 MY FAN ONLY BLOWS HARD ON 4 AND 5 AND NOTHING ON 1-3. IS THIS THE SPEED RESISTOR AND CAN THIS PART BE BOUGHT AT A LOCAL PARTS STORE OR ONLY A PONTIAC DEALER. WHERE IS THE ...

What parts must be removed and in what order to enable replacement of the resistor in the blower fan,heater/ac?? remove the hush pannel from passanger side disconnect the wiring connector for the ...

...Am Heater fan quit working, started loosing speed control then stop blowing all together. Is there resistors somewhere under dash that have blown to make the heater fan motor to stop working ? Could ...

........the lower sppeds use one fuse, hi speed uses another. this sounds like a bad blower motor resistor problem.its located in the air phlenum as it uses the air flow to keep it cool so it won`t ...

where is the blower motor relay on a 1999 pontiac grand am v6 relay or resistor? the resistor is underneath the dash board on passenger side underneath glove box. I know from personal experience that ...

...and nothing. Power for the blower starts at the fuse, goes thru the HVAC control panel, then the resistor block, then thru the high speed blower relay, then to the motor. You should have voltage

...switch? May be but next to the blower motor is the blower control module this has a series of resistors in it to change the current flow to the blower motor ,.When you call for high speed on

...could have a bad switch, you could have a bad blower motor, or you could have a bad blower motor resistor. If the bearings in the blower motor begin to seize, it will take more force (read: more ...

blower motor has 1 speed #5 what do i need to fix it Sounds like the blower motor resistor is shot. it's located under the dash on the passenger side behind the blower motor. I had the same problem ...

...replace the motor. It is held in by 3 screws. If the test light does not light, next check the resistor. You will need an ohmmeter to check the resistor. If you don't have an ohmmeter, skip the ...