Question about Pontiac Grand Am
...Head bolts--------- 22 ft lbs. Intake upper------ 18 ft lbs. Intake lower------- 10 ft lbs. Tighten vertical bolts first, the diagonal bolts, failure to do this will result in an oil leak. As far as ...
...valves. 3.1L Engine & 3.4L Engines When install or connect the check the following: - Pushrods and the rocker arms. Torque the bolts to 24 ft. lbs. (32 Nm). - Rocker arm cover using a new gasket. ...
...head. Disconnect the upper radiator hose at thermostat housing. Remove the thermostat housing. Remove both rocker arm covers. Remove the lower intake manifold bolts. Make sure the washers on the four ...
...rocker arm cover(s) and the cylinder head gasket surface(s). Position a new service valve rocker cover gasket. Position the cover(s) on the cylinder head(s). The cover is tightened in two steps. ...
...head bolts are recommended due to stretch of the old bolts. Tighten bolts in sequence, tighten the long bolts to 46 ft. lbs. (63 Nm) plue 90 degrees. Tighten the short bolts to 43 ft. lbs. (58 Nm) ...
...rocker arm assembly that bolts to the head, it is 58 Ft/lbs. If you are talking about the actual rocker arms, you tighten them till they contact the push rod and the valve stem and then you put oil ...
...rocker arms, balls and pushrods. Unfasten the cylinder head bolts evenly, then remove the cylinder head from the engine compartment. Remove and discard the gasket. To install: Clean all the gasket ...
Question about Cars & Trucks
...head overhaul, or you don't have adequate oil pressure in the lifters in question. Repeat until all rocker arms are done. Replace the rocker arm cover using a new gasket, then (in a V-engine), repeat ...
...bolt holding rocker arm assembly to head usually a 10mm bolt remove and remove rocker are and stand replace all make sure that you align stand up as you tighten bolt torque to 10-15 ft lbs + 30 ...
Question about Pontiac Cars & Trucks
...valves after head job on a 97 pontiac sunfire according to several searches on this subject: your valves require no additional adjustment. Install pushrod and rocker arms and rocker arm nuts. Tighten ...
2,020 questions posted
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,208 Questions
1,285 Questions