2001 Mazda Protege "steering belt" Questions

...you have to remove the outside belt? If so how is that belt removed? JUST LOOSEN THE BOLTS OF THE POWER STEERING PUMP TAKE OUT THE BELT FOR THE PUMP THEN REPLACE THE ALTERNATOR BELT AND STEERING

...belt drives the a/c and alternator. On the 4 cyl, the front belt drives the power steering and the a/c, and the rear belt drives the water pump and the alternator. All of these are easy to

steering belt come off. If not check if there is fluid in the steering pump resavour. If the belt is on and you have fluid you may have a bad pump. I hope this helps Regards Sam hey srinivasbham, This

...It looks like the ac belt also runs the power steering on the 1.5 engine. Removing the belt would cause you to loose your power steering. You could still drive the car, but not without

...and giving them the number on the belt. Also make sure that you are installing the belt in the correct position. i.e. putting the alternator belt on the alternator and not on the power steering,

need a diagram for 1996 mazda protege serpentine belt can any body help you don't have a serpentine belt just two drive belts one power steering and ac to crank belt and one alt belt

...other belt. Can,t find where to loosen the other belt. so i can put on the alternator belt LOOSEN BOTTOM NUT ON POWER STEERING PUMP THEN REMOVE BELT what bolt theres one on top then theres a ...

steering Pump and push it down,then remove the belt(This is the first belt you have to remove,. then loose the alternator that is located in the right side behind the engine, then remove the belt(This

...it just replacing the belt wont do the trick belt has to be properly tightened, usualy it is the power steering belt which is hard to reach and tighten so make sure that all hte belts are tight ...

...steering belts on a 2000 mazda protege 1.6l we tighten the tensioner bolt but the belt wont tighten what do i do? you might have wrong belt or you need to make sure you are following the belt ...