Question about Mazda Protege
engine fairly easily, with the usual resistance of the cam lobes you feel when you turn it. We took off the starter, took it to the parts store and they bench tested it and said it was okay, I checked
Question about Mazda Protege
engine fairly easily, with the usual resistance of the cam lobes you feel when you turn it. We took off the starter, took it to the parts store and they bench tested it and said it was okay, I checked
...engine grounds,and connections,check to make sure there is good connection at the oil sending unit,also,turn the key on,for a 1.5 second,and then off for about the same time,do this about 10 times to ...
...engine off and allow 2-3 minutes for the oil to drain back into the crankcase. check the oil level. if the oil is visable on the dipstick to the bottom of the hash marks, add 1 more quart and that ...
...engine oil. Remove or disconnect the following: Negative battery cable Hood Right-side front wheel Engine under covers Right-side fender apron seal Front exhaust pipe Engine moving control rod and ...
Question about Mazda Protege
...engine the oil pressure gauge increases at a fairly decent rate up to the 3/4 mark. When i start to slow down the gauge will decrease back to the halfway mark. This never used to happen and would ...
Engine oil: Drain or extract and replenish; renew oil filter Engine oil: Drain or extract engine oil ? Chapter. Renewing oil filter ? Chapter. Replenishing engine oil ? Chapter. Draining or extracting
...engine. Oil change was complete at this time, including changing oil seals. Turned off engine a few days ago and the Check system displayed check engine oil level. Engine oil is low. No sign of any ...
change filter, then fill with fresh oil 4 or 5 qts depending on engine, start engine check for leaks, if no leaks stop engine low car and let sit for a few min. then fill to the full mark on dip stick
471 questions posted
Usually answered in minutes!
549 Questions
373 Questions
369 Questions
255 Questions
249 Questions