2000 Mazda Protege "light sensor" Questions

Ad

Question about Mazda Protege

1 Answer

sensor. If you can't find power going to any of the sensors. Check the fuse boxes for blown fuses ( check them all with a test light) If you find a blown fuse replace it but go back to the wiring that

Ad

...light due to MAP Sensor Mazda 2001 1.6L manual trans installed new clutch kit on my 2001 Mazda Protege 1.6L manual transmission and now check engine light is on.... after checked it indicated MAP ...

Ad

Question about Mazda Protege

1 Answer

sensor. check engine light back on. Now running rough at idle. Diagnosis now is egr valve, noticed low vacume. Any thaughts? i read it could be the mass air flow sensor and or faulty spark plugs. also

Sensor. My 2002 Protege check engine light came on and it started stalling at stoplights if I didn't keep the engine revved a little. Manager at AutoZone checked the computer code for the light (P0171

Question about Mazda Protege

1 Answer

...light is on. The error code is P0420. Catalyst efficiency below threshold (Bank 1). Had converter checked and it was ok. There is a oxygen sensor before the converter and one after the converter. ...

Question about Mazda Protege

1 Answer

...blinking hold light is gone! :) So,you need to check the transmission sensor first before you check the solenoid cause in my case,the fault could be just the sensor rather than the pricey

Question about Mazda Protege

1 Answer

...sensor are good, use a 12 volt test light or voltmeter to check for power to the fan connector when the engine is running and hot. If there is no power, check the wiring from the fan relay. If there ...

light was on and replaced O2 sensor. Emissions test shows O2 sensor not ready. there are more then 1 o2 sensor find out if is a upstream or downstream sensor before installing remove the battery cable

Question about Mazda Protege

1 Answer

...light is on, and It will not turn off.. A mechanic told me that the proble was related to the Oxygen sensor in the fuse box, and that it should be replaced but to also replace the OEM sensor.. My ...

...light comes on code 0123. tried a new t.p.s. sensor and had same problem i am a licensed mechanic and need some advice on this problem. hard shift in reverse,code p0123,flashing o.d. light. all ...

Not finding what you are looking for?
2000 Mazda Protege Logo

576 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...