2000 Mazda Protege "1 time" Questions

Purchased a bosch o2 Sensor for mazda protege 5 the wiring is different from factor (2 blk 1 whte & 1 blu. bosch connector (2 whte, 1 blk & 1 gray) IF THE CONECTOR ON THE END IS THE SAME THEN ...

...or get 1 front and then 1 for right side near passenger side? new to auto repairs lol. i would replace all the mounts at the same time. it's good practice and you probably never have to do it

...1. ECU responds by locking and unlocking the car doors. Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors. Step 9: Remove the key from the ...

...your finger in #1 spark plug hole, and then turn the engine a little bit at a time, using the key. When it pops your finger out, you're close. Then turn the crank shaft by hand so the mark is at

how to aliane marks on cam shaft pulley on mazda protege 2002 1. Remove all spark plugs so that the crank shaft could be rotated easily. 2. Rotate the crankshaft to align the timing mark of the ...

how do i replace a water pump on a 1994 mazda protege 1.u need to jack the car up so u can take the passenger tire off. align the crank timing mark to top dead center with the front timing belt cover.

2001 Mazda Protege 1.6L automatic. Knocking pinging noise 2001 Mazda Protege 1.6L automatic. Had this car used for about 1 month. We initially change oil and filter, timing belt, and spark plugs ...

...time a 96 Mazda Protege from scratch With out distributor in set engine to TDC top dead center, then set your distributor to #1 cyl one on top closest to front of car, and insert with a ...

What are the timing marks for a 2000 Mazda protege 1.8L I assume you are replacing the timing belt, so just wactch the youtube video at the link 1999 03 Mazda Protege 1 8L 2 0L timing belt replacement

Ihave a 1996 mazda protege 1.8 litre engine. The car started a little hard but finally ran. Upon driving away it started runnung real rough so I parked the car. It smelled like raw gasoline inside the