thermostat is inside a housing that is held on by 2 or 3 bolts and has a heater hose connected to it. Drain and recycle the engine coolant. For 2.5L engines, remove the accessory drive belt tensioner.
...3 bolts, the thermostat is in that housing. When you remove it, have a big tray ready, all the coolant will drain when you release it. Follow rubber hose coming from top of radiator back towards ...
3. There should be 2 bolts on top off the housing. Take the bolts completely out and remove the housing from the engine block. 4. Remove the thermostat and gasket from the block and clean the location
...down,but 3 blocks later temperature goes up again,fans are working there is no leaks Replace the ...
...3.4-5.0 amps; if not, replace the motor. 6. Reconnect the fan's electrical connector. Start the engine, allow it to reach temperatures above 194°F and confirm that the fan runs. If the fan ...
...3 months ago i had overheating problems. I had the thermostat replaced and no longer had a problem. a few days ago it overheated. i checked the coolant levels and it was empty. i filled it up but ...
Question about Mazda MPV
...3 months ago and it has no leaks and no thermostat. plz gimme some ideas what this problem could be. Call the scrapyard its cooked the engine and will cost more to repair than a 10 yr old vehicle is ...
3 liter mazda mpv overheating 94 mpv over heating? i put new rad and thermostat.. there is no coolant flow in the rad and it blows only cold air inside? is the impeller on the water pump broken or ...
...thermostat housing that had broken the top half off the gasket. The leak stopped for a day. I drained the water, filled with water and coolant, now its running out again. Being as they are a tight ...
199 questions posted
Usually answered in minutes!
692 Questions
458 Questions
413 Questions
309 Questions
262 Questions