1997 Mazda MX-6 "engine start" Questions

...Start Engine fuel pressure 27-33 psi (186-225 kPa) 6. Engine running remove vacuum hose from fuel regulator fuel pressure should increase 34-40 psi (235-275 kPa) 7. if not, replace fuel regulator 8. ...

...start till the engine cools off for a bit. The temp gauge only goes to the halfway point. I've replaced the waterpump,thermostat, plugs & wires after I had bought it. Any advice would be sweet. ...

...engine start up the intake tube to see if the engine trys to run if it does it eliminates a lot of other potential reasons for a no start condition.Also try squeezing the fuel return line to see if ...

...start the car the check engine light is off ??? sounds like an O2 fault poss if it was a hard code the engine light would be stuck on so sounds like another sensor in the circuit is doing two jobs ...

1990 Mazda MX-6 - Finding Engine Number Trying to find engine no. on 1990 Mazda MX-6 - know it is on the block somewhere ... but can't locate it - any directions appreciated. The serial number (for an

start the engine again and move on..... but its a bloody pain , can any one help......SAM No one checks wires. Start the engine and start wiggling the wiring harness at different points. If it dies on

...start, when obd1 engine off test is run the only response is code 101 engine system test complete. Help! May have scored the cylinder walls and lost the ring tension. Can you give it a compression ...

...drive car the other day and died at the light, when i tried to turn over whinning noise came from engine. Initially thought it was my timing but mechanic said 'engine problem' and quoted $1200 to ...

...start the engine.To disable the fuel pump, do the following: With the engine off, remove the fuel pump fuse from the fuse box. (Your owner's manual should show you where it is.) Make sure that the ...

...start it the engine revs to 3000 rpm for about 5 seconds then comes down. then starts reving itself to about 2500 rpm up and down all the time Hi, Looks like vacuum leaks and some sensors are not ...