1995 Mazda Protege "screwdriver trick" Questions

...trick to removing them that I am missing? Usually this problem is the hazard lights, there is a switch in it, and it once and while can go bad. A small screwdriver will help get them out. But your ...

...trick. If you are still unable to budge it, try getting an oil-filter wrench from a local auto parts store. It should not pose too much of a problem with a wrench. Remember not to use the wrench to ...

...screwdriver to jam the flywheel and then remove damper bolt. alot of times if it gices me too much troulbe i remove the right front tire and use an impact gun and socket this usually does the trick. ...

...the screws on sun visor without breaking it A small screwdriver or a pry tool obtained from a parts store should do the trick. If you have a small plastic putty knife, that could also do the

...trick If you dont have a oil filter removal tool. you can use a screwdriver if you have room, use a large screw driver penetrate the side off the filter make sure you drive it far enough into the ...

...trick did not work. Could you tell me how the linkage and electric door lllockwork? stick a screwdriver in it pull the lever and open it take a pen pencil or skinny screwdriver put in latck lift or ...

...trick? there is two ways with a chisel or screwdriver and hammer hit the rim of filter closest to the engine in an anti clockwise position if this does not work belt a screw driver completely through ...

...trick was reaching up to stick a screwdriver in that hole to release the hood. It looks like the little steel ball could come loose from its clip again. It needs something to keep it captive. small ...

...trick: use a long screwdriver between the shaft and a bolt or between 2 of the bolts to hold the fan while you loosen another bolt with a wrench. Don't remove any bolts until they are all loose. Keep ...

...trick is to pop the circlip on the end of the axle shaft out of its groove in the transmission gears. Shops use a fork on the inner CV joint housing, attached to a slide hammer. What usually works is ...