1995 Mazda Protege "automatic auto shut down located" Questions

...automatic shut down relay (see that auto word there?>)
and has up to 8 reasons to cut fuel. (and spark)
next time post symptoms first. the add a wild guess for parts that dont exist, why ...

auto shutdown realy on a 1999 dodge durango It's in the Power Distribution Box under the hood. May also be called the Fuse/relay Block. The cover over the box should show the location of the automatic

...Auto Shut down relay (ASD). The power supplied to the fuel pump. Ignition coil, fuel injectors, and parts of the power module is controlled by the logic module through the Automatic Shutdown ...

auto transmission. There are 120K miles on the truck While driving my speedometer, odometer, gear indicator and tach stop working, gauge light comes on, and, most importantly, the truck will not shift

...automatic 3.8, PCM "Buzz" no spark, no fuel Previous symptoms over the last two months: Speedometer quit working Hard downshifts when slowing down ..... I was driving at 60mph, low on fuel, ...

automatic) and then turn the key to start... it starts! Sometimes it takes 3 or 4 times before it starts, but it always starts up. One thing I notice before it dies on me is the car will "lurk", as if

...Automatic shut down relay is not being shut down by PCM (DB/YL wire) goes to 12v is shut down, 0v is not. the PCM can cut the ASDR for may reasons, oil pressure or battery overheat,? many, best it to ...

...automatic was starting very hard, i`ve had to crank it good few times for a long time before it started but one day my wife came back from work, shut it down and the next day it didn`t start at all, ...

...Automatic Transmission Fluid (ATF) cooler. Locate and remove the starter cable from terminal-B on the back of the solenoid (for all four engine sizes). Disconnect the black and white cable from the ...

...Auto Temp Control ) HVAC system, so the blower motor speed is controlled by the Front blower motor speed control. This is mounted where the Blower motor resistor is located ( for the EMTC HVAC ) and ...