1991 Mazda MX-5 "best loosen rusted screw" Questions

...best as I can tell, you have to take off the front bumper which I hope is not the case. To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light ...

...or rubber mallet).Or it may be fixed to the hub with a couple of screws or bolts.The screws are best loosened with a shock tool as they are usually tight and may also be partially seized in ...

...loosen the screw that holds the housing where the ignition switch is located. Best to buy a new one as old one is a one time use bolt. Disconnect the battery prior to performing this work. Best of ...

...loosen the bleeding screw and thn try to force in the pistons they may retract. Its better you examin the caliper pistons for rust and or pits on them.An overhaul to the caliper/s would be the best ...

best but the most complex and is almost exclusively to be found on luxury cars and the latter type is mostly found in the vintage car parc and the worm-and-peg type is probably the most commonly found

...loosen the bolt. I recommend using caution when attempting any of these methods, as you don't want to cause further damage to the water pump or the engine. If you are not comfortable attempting these ...

...screw them on five or six turns (leave space between the nuts and the rim so the tire/rim has room to break loose). This offers some level of extra safety in case the car-jack slips. I make sure my ...

loosen the pads enough to lift off the whole caliper..... ......Have a piece of wire, that you can hang the caliper onto, and then hook the other end onto a convenient place.....(the suspension spring

...loosen these screws. After reading the previous issue with Honda Accord rotors, I am now wondering if I actually need to remove these 2 screws. I believe that these screws are rusted. Can anyone give ...

...best way to get broken part out as it is not flush and would rather not drill and rethread? if the guide pin is broken then the easiest way is to weld a nut to the rest of the pin. this way you can ...