1991 Mazda MX-5 "2 spark plug replacement" Questions

Ad

Question about Mazda MX-5 Miata

2 Answers

...2 problems. Leaky valve cover gasket- my spark plug holes used to fill up with oil before I replaced the gasket. Plus loose or cross threaded spark plug. The oil would be constantly leaking into the ...

Ad

...2.  This one is tougher --- From underneath the vehicle just after the catalytic converter  you should be able to see the Spark plug like O2 sensor .  The person who repaired it for me ...

Ad

Question about Mazda MX-5 Miata

2 Answers

...spark plug changes and all else with the first RX-7 when it seemed to have a problem misfiring, or not making a solid connection. It had a manual choke, so starting it was easy, but after it was ...

Question about Mazda MX-5 Miata

1 Answer

2) Drain the Oil and replace with 10W-30 with new filter 3) Check the water level in the radiator - make sure up to level 4) Put several ounces of sea-foam down each cylinder 5) Hand crank engine over

...2 coil packs and they don't go bad exactly at the same time, your symptom is most likely not related to that. Check the main fuse. Mine went bad a few months ago. It didn't blow but the inside of it ...

2 hour or longer. Engine sputters, loses power. I try feathering the accelerator but after driving slower and slower on the shoulder it finally slows and quits. I can almost immediately restart it ...

...spark plug wire. Install the intake manifold cover, if required. Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ...

Question about Mazda MX-5 Miata

1 Answer

...Spark Plug using the above Rules. Repeat. For the 3.4L V6: Firing Order: 1-2-3-4-5-6 Cylinders: ......(back) 1.......3.......5 2.......4.......6 ......(front) Ignition Coil Connections: ...

...2, 4, 6 spark plug. INSTALLATION 1. Install spark plug into cylinder head. Tightening torque : 18~22lb-ft (25~30N·m, 2.5~3.0kg-m) 2. Reconnect high-tension leads. 3. Reconnect negative battery ...

...2 Spark Plug. 8) Connect the Tester into the end of the #2 Wire. Clipping the other end to the engine block or a good ground. 9) Start the Engine. 10) Again you are looking for a strong (blue) and ...

Not finding what you are looking for?
1991 Mazda MX-5 Logo

119 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...